creep rupture strength
英 [kriːp ˈrʌptʃə(r) streŋθ]
美 [kriːp ˈrʌptʃər streŋθ]
持久强度；蠕变断裂强度
双语例句
- Meanwhile, the creep rupture strength of sheet increases along with increasing reduction in the last fire.
同时，板材的持久强度也随着最后一火变形量的增大而升高。 - Effect of cyclic stress on creep rupture strength of a cast superalloy with high Al and Ti contents
循环应力对一种高铝钛铸造镍基合金持久强度的影响 - However, when the sustained tensile stress is higher than the creep rupture strength of concrete, the creep failure occurs and three deforming phases are observed.
当持荷应力高于徐变长期强度时，混凝土在持续拉伸荷载作用下的徐变变形随时间的增长不断增加，直至发生徐变破坏。 - The effect of Mo, V and Nb on creep rupture strength of 10% Cr ferritic heat resistant steel has been studied.
研究了钼、钒、铌对10%Cr铁素体耐热钢持久强度的影响。 - Effect of alloying elements on creep rupture strength of 10% Cr ferritic heat resistant steel
合金元素对10%Cr铁素体耐热钢持久强度的影响 - The design scheme, development and adjusting method of automatic level adjusting system of lever of creep and rupture strength test machine are presented in this paper.
阐述蠕变持久强度试验机杠杆自动调平系统方案设计研制与调整方法。 - Accuracy of creep rupture strength by extrapolation
持久强度的外推精度 - Therefore, a new stress rupture equation with high reliability and confidence is derived, which overcomes the shortcomings in the current method. This equation can accurately predicted the creep rupture strength and creep life with high reliability and confidence.
本文发现并纠正了现行方法中的错误，建立了一种新的蠕变持久可靠性方程，根据该方程可以准确地预测高置信度和高可靠度的蠕变持久强度和使用寿命。 - Effects of various alloying elements on creep rupture strength and structural stability of steel 102 have been investigated with 7 heats of experimental steels, which were normalized and tempered before testing.
本文通过七炉试验钢研究了硼、钼、钨、钒和钛等元素对102钢持久强度、伸长率和组织稳定性的影响。 - The measures to improve high temperature creep rupture strength of 9~ 13Cr steel are detailed.
较详细地介绍了提高9～13Cr钢高温蠕变强度的措施。 - Creep Rupture Strength and Plasticity of Heat Resistence Steel for Stream-turbine Cylinder
汽轮机缸体用耐热钢持久强度与塑性研究 - Fe_2Mo and M_6C are very important in maintaining the long time creep rupture strength at high temperature.
Fe2Mo、M6C对维持高温长时间持久强度有重要贡献。 - High Temperature Creep Rupture Strength of Ni-Cr Coated Boiler Tubes
镍-铬系涂层对锅炉管材高温持久强度的影响 - The increase in V addition from 0.13% to 0.30% resulted in decrease of the creep rupture strength and the strength after long term ageing.
钒含量（质量分数）由0.13%增加到0.30%，试验钢的持久强度和时效后的强度下降。 - The inferior creep rupture strength of fine-grained zone in HAZ makes creep rupture strength of welded joint lowered, to reduce the width of HAZ is a effective measure to limit this deleterious affects.
HAZ细晶区蠕变断裂强度低劣导致接头蠕变断裂强度降低，减小HAZ的宽度可有效地限制这种有害影响。 - The creep rupture strength of 102 steel under the conditions of known chemical composition and given heat treatment can be estimated.
用CE可以对既定化学成分及热处理的钢的持久强度作出估量。 - The development of automatic level adjusting system of lever of rl-3/ 4 type creep and rupture strength test machine
RL3/4型蠕变持久试验机杠杆自动调平系统研制 - The creep rupture test results of ferritic/ austenitic dissimilar metal welds by nickel base alloy, austenitic and ferritic fillers show that the mismatch of creep strength between different materials is the main cause of premature failure of dissimilar metal welds during elevated temperature service.
通过用镍基合金、奥氏体和铁素体填充材料焊接的铁素体-奥氏体异种钢接头的蠕变断裂试验结果表明，材料之间的蠕变强度不匹配是异种钢接头高温运行中过早失效的主要原因。 - Coalescence, and growth of the carbides will lower the creep rupture strength.
这些析出物的聚集和长大将导致持久强度的降低。 - Creep laws are applied and show that concrete deforms slowly and no creep failure occurs when the tensile stress is lower than the creep rupture strength of concrete.
当持荷应力低于徐变长期强度时，混凝土在持续拉伸荷载作用下变形速度缓慢，并且不发生徐变破坏； - Influences of nb, Ti and C contents on creep rupture strength of high strength austenitic steel used under super high critical pressure
Nb、Ti和C含量对在超高临界压力下使用的高强度奥氏体钢持久断裂强度的影响 - Study on creep rupture strength and microstructure of ferritic heat resisting steels
铁素体耐热钢的组织与持久强度的研究 - With the increase of Nb content, the change of the creep rupture strength of HP alloy characterizes a peak value.
随Nb含量的增加，HP合金蠕变断裂强度的变化表现出极大值特征。